Bright 128x64 FSTN(+) Graphic LCD Module with White Backlight and Built-In Negative Voltage
Perfect for your next project, the NHD-12864WG-CTFH-V#N is a bright solution to show high contrast monochrome graphics with 128x64 pixels. This graphic LCD module is a FSTN positive (+) transflective display with a white backlight showing clarity in any lighting environment. Its 6:00 viewing angle provides optimal visibility from below. The built-in NT7108C controller, Parallel interface, and 1x20 thru hole connection makes integration with Arduino and similar development boards quick.
The display runs on 5.0V power with built-in negative voltage supply, making it flexible to work with. It operates between -20° and 70° C, making it dependable in extreme conditions, and it is RoHS compliant for environmental safety.
NHD-12864WG-CTFH-V#N: Technical Specifications
| Display Format | 128x64 Pixels |
|---|---|
| Display Type | FSTN (+) |
| Display Mode | Transflective |
| Optimal View | 6:00 |
| Outline L x W x H | 78mm x 70mm x 14.3mm |
| Viewing Area L x W | 62mm x 44mm |
| Active Area L x W | 56.28mm x 38.36mm |
| Supply Voltage | 5.0V |
| Backlight | White |
| Interface | Parallel |
| Compatibility | Arduino and Similar Development Boards |
| Controller Type | NT7108C |
| Connection Type | 1x20 thru hole with 2.54mm Pitch |
| Operating Temperature | -20° ~ 70° C |
| Storage Temperature | -30° ~ 80° C |
| Additions | Built-in Negative Voltage Supply |
2 beoordelingen
-
Quality display
The quality of the product is very good, as well as the manufacturing of the soldering for the connection of the Display, however I still cannot give a very complete opinion since these days when I have had the display connected to my motherboard it seems to disconnect very often; I do not know if it is because of the cables, the motherboard or the display. I will replace the cables, if it does not work properly, I will check the motherboard and if it still does not work properly, I will assume it is the display.
-
easy setup
Ordered with pin header soldered. Setup was a breeze!
