Newhaven Display Home

To help answer your questions when receiving your DevKit, we have provided a general assembly guide for each type of display that is supported by the NHDev development board.


For additional questions or technical support, try visiting our Support Forum.


STEP 1

Take your character display and ribbon cable.

STEP 2

Connect the cable to the display, there is a label advising which end connects with the display. Remember to line up pin 1 on the display to pin 1 on the cable.

STEP 3

Connect the other end of the cable to the NHDev Board, lining up Pin 1 on the cable connector to Pin 1 on the NHDev Board.

ASSEMBLY COMPLETE

See the display and NHDev board specs for further guidance on powering and using the kit.

STEP 1

Take your graphic display and ribbon cable.

STEP 2

Connect the cable to the display, there is a label advising which end connects with the display. Remember to line up pin 1 on the display to pin 1 on the cable.

STEP 3

Connect the other end of the cable to the NHDev Board, lining up Pin 1 on the cable connector to Pin 1 on the NHDev Board.

ASSEMBLY COMPLETE

See the display and NHDev board specs for further guidance on powering and using the kit.

STEP 1

Start with your NHDev Board and FFC to thru-hole adapter board.

STEP 2

Connect the ribbon cable to the adapter board. There is a label advising which end connects with the display, connect this end to the adapter board.

STEP 3

Connect the other end of the cable to the NHDev Board. Remember to line up Pin 1 on the cable connector to Pin 1 on the NHDev Board.

STEP 4

Connect the COG display's flex cable into the adapter board.

STEP 5

Then connect the COG display's backlight cable into the adapter board.

ASSEMBLY COMPLETE

See the display and NHDev board specs for further guidance on powering and using the kit.